Increased volume of the combustion chamber ensures complete combustion of the fuel. Convective surface of u-shaped pipes reduces the temperature of flue gases from the boiler. While high-quality thermal insulation minimizes heat loss through the boiler walls.

It prevents air from entering the boiler furnace and allows the use of light thermal insulation up to 50 mm thick. With decorative lining.

Modern burners are used in design of the combustion chamber with efficient fuel combustion.

Due to the small volume of water in the boiler and the high speed of water movement in the pipes, the time for reaching the set mode is 180 minutes.

The experience and operating conditions of russian heating systems are taken into account, so the service life of the boilers is more than 20 years.

The casing is made of profiled sheets, painted in gray and red, the corners of the case are rounded. The company logo is displayed on the side walls

This is the main advantage of water-tube boilers over fire-tube boilers.

Boilers with a capacity of up to 40 mw are manufactured in one package at the factory. It reduces the time and cost of installation on site, as well as the delivery of equipment.

It allows you to choose a boiler according to the specifications for the implementation of projects or the reconstruction of existing boilers.

It allows you to economically consume the burned fuel when the boiler is running, while achieving maximum efficiency.

When water enters the boiler, it is pumped through half of the pipes of the convective part. Then, the heated water passes through the screens and is heated in the second half of the convective part. This will ensure quick access to the set operating mode and low hydraulic resistance due to a decrease in the dynamic and kinematic viscosity of water, that decreases the required pump power.

The design of the boiler will allow access to any node, which reduces the time and cost of equipment repairs.