• +7 (800) 5555 912
ENG
ENG

Hot water boiler GEOTHERM WGB (3P) 11,63

Specifications

Specifications Units of phys. qt Standard size
Boiler type 11,63
Heating capacity kW 11630
Water temperature at the exit of the boiler ◦С 110 150
at the entrance to the boiler 70
70
EC (efficiency coefficient) of boiler Natural gas % 94,8
93
diesel 92,6
91,3
Fuel consumption Natural gas Nm3/h 1226,4 
1242
diesel kg/h 1065,1  1078,1
Exhaust gas temperature Natural gas ◦С 134 
181
diesel 174
199
Aerodynamic resistance of the boiler (without burner) Pa 1650
1700
Hydraulic resistance MPа 0,19 
0,206
Design water pressure at the inlet MPа 0,9
1,6
Water flow through the boiler t/h 250
125
Specific emission of nitrogen oxides Natural gas g/m³ 0,08
0,08
diesel 0,16
0,16
Adjustment range % 30-100
30-100
Boiler weight (without burner, without water) kg 16000
16000
Water volume of boiler 2,1
2,1
Heating surface area 322,3
322,3

PRODUCT DESCRIPTION

GEOTHERM ® WGB (3P) series boilers are designed to produce hot water. Boilers are focused on heat supply of industrial and domestic facilities.

GEOTHERM ® WGB (3P) series boilers are produced with three temperature schedules 70-95 °C; 70-110 °C; 70-150 °C.

Boilers of the GEOTHERM ® WGB (3P) series are produced with a capacity of 0.25 to 15 MW.

The fundamental difference between the boilers of the GEOTHERM ® WGB (3P) series from the boilers of the GEOTHERM WGB(P); GEOTHERM WMB; GEOTHERM WGB(V) series is that the exhaust gases after burning the torch of the burner unfold in the furnace, pass through the fiston, unfold again and pass through the convective surface. The main advantage of boilers of this series is that they can be used to replace old equipment during the reconstruction of boiler houses because boilers of the GEOTHERM ® WGB (3P) series have a small overall size in length. The small overall size in length is achieved by the fact that the convective surface is located above the boiler furnace, and not behind it as in GEOTHERM ® WGB (P) series boilers.




Main components of GEOTHERM ® WGB (3P) series boilers:

  • Collector frame - serves to distribute water flows depending on the hydraulic circuit of the boiler and the connection of the boiler to the external strapping.
  • The convective section is the main part of the boiler pipe system.
  • The support frame serves as the base for the installation of the boiler pipe system.
  • Stiffness belt - serves as a frame to ensure the rigidity of the boiler.
  • The flue duct with an explosive valve - serves as a channel for the discharge of exhaust gases.

The design of the combustion chamber and the efficient combustion of fuel with modern automated burners allows achieving low emissions of nitrogen oxides.

Advantages of the boiler geotherm series:

High efficiency

Gas-tight tube

Low NOx emissions

Quick launch

Reliable and simple performance

Modern design

Possibility to use boilers in open heating systems

Package supply

Wide size range from 0,25 to 68,9 mw

Application of boilers with burners from leading European and Russian manufacturers

Low hydraulic resistance

Simplified repairs