Press compactor

The stationary press is designed in such a way as to meet the high capacity requirements for pressing industrial waste, bulk cardboard and paper. The size of the loading hopper can be 7 m3. With one pressing cycle, the press is able to press about 1.8 m3 of mass into an additional container.

The press can press with a force of up to 45 tons. 6-8 tons of cardboard are pressed into a container with a volume of 30 m3 at this pressure. This press has a more powerful hydraulic unit located at the back of the press. The slider is about 1500 mm wide. 

LR version (manual)

The maintenance staff connects the press to the container with a ratchet, and before disconnecting from the filled container, the press will close the container using two tubes, which then the maintenance staff will fix in the container manually.

Version LH (automatic)

The press is connected to the container automatically by hydraulic hooks, and after connection, a movable lock will open. After filling the container, it will automatically close with a falling shutter (guillotine) and detach from the press. 

The stationary press is fixed to a flat concrete foundation with anchor bolts. The operation of the press is controlled by buttons from the remote control. At the request of the customer, an audible and optical alarm of the press stroke or container filling can be installed.

Options:

• loading hopper lid;
• aluminum cover casing;
• closing the lid;
• increased height of the hopper;
• increased height of the side wall;
• optical launch sensors;
• rubber seal of the gate or valve;
• elastic suspension of the hydraulic device, more powerful pump and motor;
• oil cooling or oil heating;
• GSM module;
• remote control from the ramp;
• multicomponent paints;
• fencing.